![]() ![]() This damage can cause loss of steering control which could result in personal injury. Disconnect the intermediate shaft from stub shaft.įailure to disconnect the intermediate shaft from the rack and pinion stub shaft can result in damage to the steering gear and/or intermediate shaft.Remove the intermediate shaft lower pinch bolt.Install an engine support fixture J-28467-A, or the equivalent.Install the intermediate shaft seal and the intermediate shaft-to-stub shaft pinch bolt.Install the high pressure hoses to the steering gear and install the air cleaner.Install the front wheels and lower the vehicle.Install the tie rod ends to the steering knuckles, install the retaining nuts and insert new cotter pins.Install the bracket bolt to the crossmember under the air management pipe.Raise the rear of the cradle and install the mounting bolts.Install the gear assembly through the left wheel opening and install the mounting bolts.Remove the rack and pinion mounting bolts, then the gear assembly through the left wheel opening. ![]() If equipped, remove the rack and pinion heat shield.įig.If the rear of the cradle is lowered too far, the engine components nearest the cowl may be damaged. Remove the 2 rear cradle mounting bolts and lower the rear of the cradle about 4-5 in.If equipped with an Air Management pipe, remove the bracket bolt from the crossmember.Using tool J-6627 or BT-7101, press the tie rod ends from the steering knuckle. Remove the cotter pins and nuts from both tie rod ends.Raise and support the vehicle on jackstands, then remove both front wheel and tire assemblies.Remove the air cleaner and disconnect the pressure hoses from the steering gear.Raise the intermediate shaft seal and remove intermediate shaft-to-stub shaft pinch bolt.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |